REF 1813: Male part with 45° inclined base for optimal incorporation and respect of the periodontium.
Cast in hard alloy. Shorten the lower part of the male part and round off the occlusal face of the male part after processing.
For laboratory use only.

• Burn-out plastic
• Height of male part: 5.9 mm (can be reduced by up to 3 mm)
• Ø male part: 1.8 mm
• Ø parallelogram rod: 2.35 mm

REF 1803 :

Male part with extension as paralleling rod.
Cut the rod after positioning with a heated instrument. Cast in hard alloy. Round off the occlusal surface of the male part after processing.
For laboratory use only.

• Burn-out plastic
• Height of male part: 5.9 mm (can be reduced by up to 3 mm)
• Ø male part: 1.8 mm
• Ø parallelogram rod: 2.35 mm